How To Jump Start An Automatic Car With Cables

Be sure the cables and clamps to the jump starter pack are not in the way of any moving engine parts when the car is started.
How to jump start an automatic car with cables. Turn the power switch to the jump starter pack to off if equipped with one. If the car wont start the next time you use it the battery isnt holding a charge and needs to be replaced. Also known as a push start roll starting a vehicle is an option for emergencies only when calling a tow truck or jump starting with battery cables is not an option. How to start an automatic car with a dead battery.
Drive around for at least 15 minutes to recharge your battery. If its clear you can start the engine in the car with the good battery. Before you attempt to jump start the car make sure both batteries are of similar voltage or you risk damaging electrical components. Put the transmission into second gear and release the hand brake.
Turn the power switch to the jump starter pack on if equipped with one and start the car. Then attempt to start. If the jump works and your car starts dont shut off your engine. As soon as it starts press the brake and give it gas.
When the car reaches 5 miles an hour try starting the car by turning the key. Get the cars as close together as possible but. If your car doesnt start check out these tips for troubleshooting a car that wont start. If your car wont start you can get it moving with a roll start as a temporary solution.
Put the car in neutral and roll it to the top of an incline.